Choose the code and hazard
Select the bridge pushover study. In Bridge seismic, set Code to AASHTO Guide Spec or Caltrans SDC 1.7.
The design spectrum comes from the study’s hazard (SDS, SD1) and PGA coefficient As (g), the spectrum at T = 0. A new bridge study starts with SDS 1.0 g, SD1 0.6 g and TL 8 s, and As = 0.4 SDS.
Run the study again after you change these values.
Run the check
Show the results of the bridge pushover or time history, then choose Results › Bridge capacity check. The Output panel lists each bent and direction:
- Δc, the capacity, with the hand value beside it;
- ΔD, the demand;
- μD against its limit;
- T, the bent’s period;
- OK, or the checks that fail.
The last line gives the status of the code values used.
Where the capacity comes from
- Pushover: the seat displacement where a hinge section first reaches a strain limit, the core’s εcu or the bar’s reduced ultimate strain.
- By hand, when the pushover gives none: Δc = Δy + θp (L − Lp/2), with θp = Lp (φu − φy) from the idealised moment–curvature.
A bent is a cantilever along the bridge and a frame in double curvature across it, if it has more than one column.
Where the demand comes from
From the design spectrum, per bent, using the bent’s weight W and pushover stiffness K:
- T = 2π √(W / (g K))
- ΔD = Rd Sa g (T / 2π)², with Rd = (1 − 1/μD) T*/T + 1/μD and T* = 1.25 Ts
- iterated on μD = ΔD / Δy
After a bridge time history, the demand is the bent’s peak seat displacement relative to its base.
The limits
| Check | AASHTO Guide Spec | Caltrans SDC 1.7 |
|---|---|---|
| Displacement | ΔD ≤ Δc | ΔD ≤ Δc |
| Ductility demand μD, single-column bent | ≤ 5 | ≤ 4 |
| Ductility demand μD, multi-column bent | ≤ 6 | ≤ 5 |
| Ductility capacity μc | — | ≥ 3 |
| P-Δ: Pdl ΔD | ≤ 0.25 Mp | ≤ 0.20 Mp |
Status of the code values
The Caltrans limits above were checked against SDC 1.7. The AASHTO Guide Spec values have not yet been checked against the published document. The program prints this status with every check and in the report.
The Bridge capacity and demand chart in Results › Seismic charts shows every bent and direction at once. Its second view shows the ductility demand against the limit.
The bridge seismic report
Choose Results › Bridge seismic report, or open it from Reports in the Explorer. It takes the bridge pushovers and time histories chapter by chapter:
- the design spectrum and a summary table of every bent and direction;
- per bent and direction: the section, the moment–curvature, the bent pushover, the capacity and demand calculations, and the verdict.
Save it as PDF, Word or HTML.
What you learned
- The check compares capacity and demand for every bent, along and across.
- The capacity comes from the bent pushover, or by hand when the pushover gives none.
- The demand comes from the design spectrum, or from the time history peak.
- The bridge seismic report collects it all.