Open the sample
The four-leg jacket stands on four piles in 60 m of water. It has a deck, topsides loads, the 100-year storm wave and a clay soil profile.
- Start FEA Offshore. On the first start the Workflows panel opens as well. You can close it for now.
- Click File › Samples and choose Four-leg jacket.
The 3D view shows the jacket with the sea surface and the seabed.
Look at the offshore data
Everything about the sea is in the Offshore folder of the Explorer. Its badge shows the water depth. Inside it are the sea state, the soil layer, the deck, the topsides wind area and the design cases.
- Click the Offshore folder. The Properties panel shows the site, the hydrodynamic coefficients, the current and the marine growth.
- Click 100-year wave to see its theory, height and period, and its wave length and steepness.
- Click a leg in the 3D view. Its Properties have an Offshore group: hydrodynamic loads, flooded, shielded, marine growth and pile.
| Item | In the sample |
|---|---|
| Design code | API RP 2A-WSD |
| Water depth | 60 m |
| Design wave | Stokes 5th order, H 18 m, T 14 s |
| Current | 1.2 m/s at the surface, 0.3 m/s at the seabed (1/7 power law) |
| Wave kinematics factor / current blockage | 0.88 / 0.8 |
| Marine growth | 50 mm from +2 m to −40 m |
| Soil | Clay, 0–90 m, cu 40 to 280 kPa |
| Design cases | 100-year storm from 0°, 45°, 90° and 135°, wind 38 m/s |
Run the Wave study
The Wave study moves the design wave through the structure at 36 positions over one period. With soil springs in the model, it solves the positions of highest base shear and overturning moment. This sample runs the four storm cases in one study.
- In the Explorer, open Studies and select the Wave study.
- Press F5 (Analysis › Run analysis). You can also use Offshore design › Wave.
- Wait for the progress card to finish. Esc cancels.
The model locks once it has results. To edit it again, click Unlock model. This removes the results.
Read the results
- Click Displacement for the deflected shape, then Member forces for the axial forces.
- Click Animate to play the wave positions.
- Open the Chart. Wave loads plots the base shear, the overturning moment and the wave elevation over one period. Design cases compares the cases.
- Click Offshore design › Case results for the maximum base shear, overturning moment and deck load of each case.
- Click a member to read its values in the Results panel.
Run the code check
Code check uses the results that are shown and the code of the environment, here API RP 2A-WSD. It checks every tubular member (axial, bending, combined and hydrostatic) and the brace–chord joints (punching shear). Storm cases get the one-third allowable stress increase.
- Click Offshore design › Code check.
- Members are coloured by utilization. Utilization turns the colours on and off.
- Click Check table. The highest values come first.
Make the report
Set up the 3D view first (results, utilization colours, viewing angle). The report includes a picture of it.
- Click File › Report (Ctrl+P). The report has the model, the offshore environment, the results and the checks.
- Save it as a web page, or print it to PDF.
What you learned
- The Offshore folder in the Explorer holds the sea, the soil and the design cases.
- F5 runs the study selected in the Explorer.
- The Chart and Case results show the wave loads; Code check colours the members by utilization.
Next, build the same jacket yourself, step by step.